Jump to content

Search the Community

Showing results for tags 'bug'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • PIC Embedded Programming
    • BoostC and Chameleon compilers programming
    • BoostC porting source code
    • BoostC++ compiler programming
    • BoostBasic compiler programming
    • Assembler programming PIC
    • Novo RTOS Programming
    • Hardware PIC
    • Enhancement Requests
    • Bug Reports

Found 1 result

  1. Hi guys, In December I downloaded the installer (and purchased the licence) for the extra plugins pack for v7.05. Plugins appear to have installed without error, registered as expected, and most seem to function correctly. The Variable PSU simulator shows up at the bottom of the plugin list, but when I attempt to select it, nothing happens except for the following message in the Build pane of the Output window: Abort building... This happens every time I try to select Variable PSU, regardless of what project is loaded, or whether other plugins are already in use, or whether I'm in simulation mode or not. * * * As a side note - I wanted to use the Variable PSU as a voltage source for simulating input in a short PIC16F877A A/D program. Because the variable PSU isn't available, I brought up the Signal Generator plugin, and attempted to use it as a source of DC voltage on RA0. The plugin itself seemed ok, and when I connected the Digital Voltmeter plugin to the same pin and started the simulator, the voltmeter indicated the correct voltage set on the Signal Generator... but I never saw a non-zero value on the A/D registers. This is most likely a problem with my code, but I can't find a known-good, simple, single input A/D program written in sourceboost. I haven't given up looking, but if someone could share a very short test program just using RA0 of the '877 or '877A, I'd be grateful. Thanks.
×