Jump to content

jaydag71

Members
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

About jaydag71

  • Rank
    Newbrie
  1. Hi, I have one of the EZ-controller modules, and am wondering how to implement C with it, as I have used MPlab only a very little bit and only really run the example program so far, but would like to get some small DC motors going and all sorts of other sensors, but am a loss as to where to start being a beginner to programming in asm and C (but not so bad with C). also I am wondering what the TX and RX pins on the top of the board, (not the programming pins, but the other two sets of three..) what are these typically used for, and can they be used to program another target PIC, or controller?
×
×
  • Create New...